Imagine turning on your wipers in the rain, and they don't move, even though the motor is running. This can happen when the mechanism that drives the wiper blades fails. In this case, a Wiper Linkage Replacement will help. We will quickly remove the old part, install a new one, and ensure that the wipers function properly, allowing you to drive safely even in bad weather.
When should you pay attention to your wipers?
- The wiper blades do not move when turned on
- The wiper motor runs, but the blades remain stationary
- The wipers fall out of their mounts during operation
- The blades move jerkily or intermittently
- There is corrosion or sticking around the wiper mounts
- The blades move out of sync or in the wrong trajectory
- There are squeaking or unusual sounds when the wipers operate
What does our service include?
- Removing the panel under the windshield for access to the mechanism
- Removing the old wiper linkage
- Installing the new linkage and checking its secure fit
- Mounting the wiper arms and blade attachments
- Testing the wipers after reassembly
- Cleaning and lubricating moving parts if necessary
Additional information about the service
A Wiper Linkage Replacement is necessary when the mechanism that drives the blades stops functioning due to wear or damage. This component converts the motor's rotation into the back-and-forth motion of the wipers, and if it fails, the blades simply do not move, even though the motor is operational. We always start with a thorough diagnosis to ensure that the linkage is indeed the cause of the problem.
Diagnosis and Preparation
Our specialists remove the protective panel under the windshield to access the mechanism. We check the condition of the ball joints and the linkage mounts. If corrosion or significant wear is found, it confirms the need for replacement. Sometimes, with minor wear, we can clean and lubricate the parts, but more often than not, restoring normal function requires installing a new component.
The Replacement Process
We carefully remove the old linkage to avoid damaging other parts. The installation of the new linkage is done with careful attention to its fit and mounts. If the mounts are sticking due to rust, our technicians thoroughly clean and treat them to ensure the new mechanism operates smoothly. After installation, we reattach the wiper arms and check that the blades move smoothly, synchronously, and without excessive noise.
Final Checks and Recommendations
After reassembly, we always turn on the wipers and observe their operation. If necessary, we additionally lubricate the moving parts to prevent premature wear. We recommend always using quality blades and regularly checking the mechanism, especially before the rainy or snowy season, to avoid issues on the road.
