Imagine pressing the brake pedal and it feels soft or sinks down, while your car doesn't respond as quickly as it used to. This could indicate issues with the brake cylinders. We offer Brake Cylinder Replacement to restore the reliability and safety of your braking system. During the process, we carefully remove the old cylinders, check the condition of all related components, and install new ones, so you can drive again without unnecessary risks.
When Should You Consider Brake System Repair?
- The brake pedal feels soft or sinks down
- There is a leak of brake fluid near the wheels
- The brakes respond slowly or weakly
- Strange noises occur when braking with drum brakes
- After replacing brake pads, the car behaves erratically when braking
- The brake fluid warning light is on or flashing on the dashboard
- Brake fluid is depleting quickly without visible reasons
What Does Our Service Include?
- Removing the wheel and disassembling the brake pads
- Disconnecting and removing brake hoses from the cylinders
- Removing old brake cylinders and installing new ones
- Cleaning the inner surface of the brake drum
- Checking the thickness and condition of the brake pads
- Lubricating moving parts with a special compound
- Bleeding the brake system to remove air
Additional Information About the Service
Brake Cylinder Replacement is an essential part of maintaining drum brakes, helping to ensure the safety and effectiveness of your vehicle's braking system. The brake cylinder is responsible for pressing the pads against the drum and providing the necessary brake fluid pressure. If the cylinder fails, fluid may leak, reducing braking efficiency and potentially leading to an emergency situation.
Diagnosis and Preparation
Our specialists begin with a thorough inspection of the brake system. We remove the wheel and pads to check the condition of the drums and the thickness of the pads. We pay special attention to the condition of the cylinders - if there are signs of leakage or corrosion, it's better not to take risks. We recommend replacing both cylinders at once, as they work in pairs and wear out approximately equally.
Replacement Process and Maintenance
During the replacement, we carefully remove the brake hoses and old cylinders to avoid damaging other components. We install new cylinders, then thoroughly clean the inner surface of the drum from dirt and apply lubricant to the moving parts for smooth operation. Sometimes it is possible to restore individual components, but in the case of cylinders, replacement is more reliable - this eliminates the risk of leaks and reduces the likelihood of recurring problems.
Final Checks and Recommendations
After installing the new cylinders, we bleed the brake system to remove air and restore proper pressure. This is an important step for safety. We also check the condition of the pads and drums to ensure that the entire system is functioning properly. If the pads or drums are worn, we recommend replacing them along with the cylinders for the best results. We ensure that you receive a complete range of services so you can drive with peace of mind.
